News, tips, and product updates from Suburban Wholesale & Supply
754 posts total
ASCEND Composite Cladding can be installed during an Iowa winter, but the manufacturer prohibits installation below -5°F. Cold-weather projects require careful storage, straight controlled cuts, correct expansion clearances, properly adjusted fasteners, dry wall conditions, and safe access around snow and ice.
Read More →ASCEND outside corner posts must be installed over properly flashed corners, positioned with the correct top and bottom clearances, and fastened so they can move with temperature changes. Learn how to install, overlap, fasten, and finish ASCEND outside corners without restricting expansion or damaging the accessory.
Read More →ASCEND Composite Cladding can often be installed over existing wood or vinyl siding when the existing wall is structurally sound and a smooth, flat substrate is created. Learn when an overlay is appropriate, when complete siding removal is the better choice, and how proper wall preparation affects long-term performance and warranty coverage.
Read More →Finishing ASCEND Composite Cladding at soffits and gable peaks requires properly sized receiving channels, accurate angle templates, profile-specific expansion clearances, and finish trim where horizontal cuts remove the plank’s nail hem. Learn the correct process for 7-inch Plank and 12-inch Board & Batten.
Read More →Installing ASCEND Composite Cladding around windows and doors requires a properly flashed opening, compatible receiving channels, drainage paths, profile-specific expansion clearances, accurate panel cuts, and finish trim where a plank or Board & Batten panel loses its locking or fastening edge.
Read More →The first course of ASCEND Composite Cladding establishes the alignment for the entire wall. Learn how to properly install the starter strip, level the first course, engage the first plank, maintain required clearances, and avoid installation mistakes that can affect appearance and warranty coverage.
Read More →Installing ASCEND 12-inch Board & Batten requires a balanced wall layout, code-compliant weather-resistant barrier, properly installed receiving channels, straight panel cuts, profile-specific clearances, and correct fastening. Learn the step-by-step process, including wall preparation, panel layout, finish trim, gables, openings, and common installation mistakes.
Read More →ASCEND fastener spacing depends on the profile, accessory, substrate, and required wind-load performance. Current installation guidance calls for 7-inch Plank fasteners at 16 inches on center, Board & Batten fasteners every 8 to 12 inches, staggered plank-overlap fasteners every 8 inches, and starter-strip fasteners every 8 inches.
Read More →ASCEND Composite Cladding should be installed with galvanized steel or other corrosion-resistant nails, staples, or screws that meet the manufacturer’s published dimensions. Fasteners generally require at least 1-1/4 inches of penetration into solid nailable material, must be spaced according to the profile and wall assembly, and cannot be driven tightly against the nail hem.
Read More →ASCEND Composite Cladding can be installed with common professional siding and carpentry tools. Contractors typically need measuring and layout tools, a circular saw with an approved blade, tin snips, an angle grinder, a utility knife or scoring tool, fastening equipment, safety gear, and profile-specific tools for panel removal or replacement.
Read More →ASCEND Composite Cladding is an insulated exterior cladding system that combines a glass-reinforced polymer surface with graphite-infused polystyrene insulation. Current manufacturer literature lists 21 colors, 7-inch Plank and 12-inch Board & Batten profiles, thermal performance up to R-2.0, Class A flame-spread performance, and a transferable lifetime limited warranty—subject to the controlling technical, installation, testing, and warranty documents.
Read More →ASCEND 7-inch Composite Plank measures 12 feet, 3 inches long, has an 8.25-inch total width, a 7-inch installed exposure, and a 3/4-inch projection. Each carton contains 14 planks and provides approximately one square, or 100 square feet, of nominal coverage.
Read More →Ready to price out your next project?
Request a Quote